Thermal SIL PAD Materials
Thermally conductive, tacky, fiberglass-reinforced insulating material
This thermally conductive, fiberglass-reinforced silicone insulator pad performs well under clamping pressure. Perfect for high-performance applications requiring electrical isolation and cut-through resistance.
All marks used are trademarks and/or registered trademarks of Henkel and its affiliates in the US, Germany, and elsewhere.
- Description
- Technical specification
BERGQUIST® SIL PAD® TSP A2000 is ideal when you’re working with high performance applications where electrical isolation and cut-through resistance are paramount. This electrically insulating, silicone based, thermally conductive material consists of a cured silicone elastomeric compound coated on both sides of a fiberglass reinforcement layer. It performs brilliantly under clamping pressure up to 200 psi, and is offered as 305 mm x 305 mm (12" x 12") sheets, 305 mm (12") x 250 rolls, or in custom configuration on request.
-
Thermal impedance: 0.42°C (33°F) -in2/W (@50 psi)
-
Elastomeric compound coated on both sides
-
Less sensitive to clamping pressure due to smooth surface finish
- Product category:
- Thermal SIL PAD Materials
Technologies:
-
Thermal management, sil pads
- Carrier film thickness:
- 0.051 mm
- Dielectric breakdown voltage:
- 6000.0 Vac
- Dielectric constant, @ 1kHz:
- 7.0
- Flame rating:
- V-0
- Operating temperature:
- -60.0 °C - 180.0 °C
- Phase change temperature:
- 60.0 °C
- Shore hardness, ASTM D2240, Shore A:
- 80.0
- Standard thickness:
- 0.254 mm
- Thermal conductivity:
- 2.0 W/mK
- Thermal impedance, ASTM D5470, @ 50 psi:
- 0.42 °C-in²/W
- Volume resistivity:
- 1×10 Ohm m
FAQ
The ISO certification is the adoption of a quality management system that is a strategic decision of the organization. This International Standard specifies requirements for a quality management system where an organization: a) needs to demonstrate its ability to consistently provide product that meets customer and applicable regulatory requirements, and b) aims to enhance customer satisfaction through the effective application of the system, including processes for continual improvement of the system and the assurance of conformity to customer and regulatory requirements.
Each application has specific characteristics (e.g., surface finish, flatness tolerances, high pressure requirements, potential burrs, etc.) that determine which SIL PAD product will optimize thermal performance. Select a minimum of two pads that best fit the application, then conduct testing to determine which material performs the best.
