Thermal SIL PAD Materials
Thermally conductive soft pad material with natural tack on both sides
This fiberglass-reinforced elastomeric material has exceptional thermal performance and low compression force. Available in both sheet and roll form, it’s perfect for automated pick and place process in high volume assemblies.
All marks used are trademarks and/or registered trademarks of Henkel and its affiliates in the US, Germany, and elsewhere.
- Description
- Technical specification
BERGQUIST® SIL PAD® TSP 1800ST is a fiberglass-reinforced thermal interface material, which is naturally tacky on both sides. It’s available in both sheet or roll form, allowing excellent automated pick-and-place processing in high volume assemblies. The pad material is repositionable and designed to be placed between the electronic power device and the heat sink. Ideal for use with power supplies, automotive electronics and motor controls. Exhibits superior thermal performance and low compression forces.
-
Natural tack on both sides keeps position secure
-
Suitable for automated pick and place processing from rolls
-
Low compression force due to softness
-
Excellent thermal performance
- Product category:
- Thermal SIL PAD Materials
Technologies:
-
Thermosets, epoxy
-
Thermal management, circuits and substrates
-
Thermal management, sil pads
-
Thermal management, silicone pads
- Carrier type:
- Fiberglass
- Color:
- Blue
- Flame rating:
- V-0
- Operating temperature:
- -60.0 °C - 180.0 °C
- Standard thickness:
- 0.203 mm
FAQ
BERGQUIST® SIL PAD TSP 1800ST and BERGQUIST® SIL PAD TSP 1100ST wet-out the application surfaces at very low pressures. Optimal thermal performance is achieved at pressures as low as 50 psi.
BERGQUIST® SIL PAD TSP 1800ST and BERGQUIST® SIL PAD TSP 1100ST have an inherent tack on both sides of the material. This inherent tack is used instead of an adhesive. The tack provides sufficient adhesive for dispensing from the carrier liner and placement on the component. BERGQUIST® SIL PAD® TSP 1800ST and BERGQUIST® SIL PAD TSP 1100ST can be repositioned after the initial placement.
Each application has specific characteristics (e.g., surface finish, flatness tolerances, high pressure requirements, potential burrs, etc.) that determine which SIL PAD product will optimize thermal performance. Select a minimum of two pads that best fit the application, then conduct testing to determine which material performs the best.
The ISO certification is the adoption of a quality management system that is a strategic decision of the organization. This International Standard specifies requirements for a quality management system where an organization: a) needs to demonstrate its ability to consistently provide product that meets customer and applicable regulatory requirements, and b) aims to enhance customer satisfaction through the effective application of the system, including processes for continual improvement of the system and the assurance of conformity to customer and regulatory requirements.