Part no. (SKU/IDH):
2565509
IDH Name:
LOCTITE® PC 7332 Nordbak Wear Prevention Coating, 10 kg Hobbock/Pail
Wear resistant coatings
High-performance, wet and dry abrasion-resistant coating
A 2-part epoxy resin, designed to protect, rebuild and repair manufacturing equipment subject to severe erosion and abrasion.
Part no. (SKU/IDH):
2565509
IDH Name:
LOCTITE® PC 7332 Nordbak Wear Prevention Coating, 10 kg Hobbock/Pail
All marks used are trademarks and/or registered trademarks of Henkel and its affiliates in the US, Germany, and elsewhere.
-
{{#data}}
{{#distributor.isVisible}}
{{#distributor.isExpanded}}
- {{^distributor.unique}} {{/distributor.unique}} {{/distributor.isExpanded}} {{^distributor.isExpanded}} {{/distributor.isExpanded}} {{/distributor.isVisible}} {{/data}}
- Description
- Technical specification
LOCTITE® PC 7332 Nordbak Wear Prevention Coating is a high-performance, wet and dry abrasion-resistant epoxy resin system. It is designed to protect, rebuild and repair high -wear areas of manufacturing equipment, such as desulphurization pumps and ducts, slurry pumps and pipes, and slag granulation pumps, which are subject to severe wet-abrasion. It can also be used for particle abrasion under dry conditions in conduit elbows, chutes and other equipment. It is trowelable, non-sagging and requires no additional tooling.
-
Best-in-class resistance to wet and dry fine-particle abrasion
-
Tolerant to manually abraded and wet surfaces
-
Easy to mix and apply; trowelable and non-sagging
-
Good dry and wet temperature resistance
-
Functional cure in 6 hours
- Product category:
- Wear resistant coatings
Technologies:
-
Thermosets, 2K general epoxy
- Application method:
- Trowel
- Applications:
- Protective coating
- Colour:
- Grey
- Cure type:
- Room temperature (ambient) cure; Two component mix
- Key characteristics:
- Chemical resistant; Erosion resistance: High; Sag: non-sag
- Mix ratio, by volume:
- 4:1
- Mix ratio, by weight:
- 4:1
- Operating temperature:
- < 120.0 °C (< 248.0 °F)
- Physical form:
- Paste
- Recommended for use with:
- Metal
- Shore hardness:
- 85.0
- Work life:
- 30.0 min.
FAQ
A successful application is largely dependent on surface preparation. The application surface must be free from all contamination. Removal of oil, grease, dust, rust and for most products, moisture, will greatly enhance application success. For more detailed surface preparation techniques, refer to product description sheets.
If a part is cold and the ambient air is warm, cure time will be extended. Both the air and the part should be at room temperature to get the prescribed cure time and strength.
-
{{#data}}
{{#distributor.isVisible}}
{{#distributor.isExpanded}}
- {{^distributor.unique}} {{/distributor.unique}} {{/distributor.isExpanded}} {{^distributor.isExpanded}} {{/distributor.isExpanded}} {{/distributor.isVisible}} {{/data}}
