Part no. (SKU/IDH):
231787
IDH Name:
LOCTITE® 4031, 20 g Bottle
Instant adhesives
Low-bloom adhesive for medical device assembly
A 1-part, low-odour, low-bloom, medium-viscosity instant adhesive ideal for aesthetic applications in the assembly of medical devices.
Part no. (SKU/IDH):
231787
IDH Name:
LOCTITE® 4031, 20 g Bottle
All marks used are trademarks and/or registered trademarks of Henkel and its affiliates in the US, Germany, and elsewhere.
- Description
- Technical specification
LOCTITE® 4031 is a low-odour, low-bloom, medical device-grade instant adhesive. The medium-viscosity product is ideal for applications where odour and/or blooming are a concern. It provides rapid bonding of metals, elastomers and plastics, including difficult-to-bond plastics (PP, PE, PTFE) when used in conjunction with a primer such as LOCTITE® SF 7701. LOCTITE 4031 is tested to Henkel’s ISO 10993 protocols for use in disposable medical devices.
-
Low odour for applications where vapour control is vital
-
Low bloom for cosmetic applications
-
Medium viscosity for gaps of approximately 0.2 mm (0.008")
-
Bonds plastics, rubbers and metals
-
ISO 10993 bio-compatible
- Product category:
- Instant adhesives
Technologies:
-
Cyanoacrylate
- Chemical basis / base:
- Alkoxyethyl
- Color:
- Ultra clear
- Fixture time:
- 20.0 sec. - 60.0 sec.
- Gap fill:
- 0.15 mm
FAQ
LOCTITE® Medical Device Grade Adhesives have been tested to Henkel's ISO-10993 biocompatibility protocols, making them candidates for use in disposable medical devices. They are not intended for implants and (invasive) prostheses.
ISO-10993 Biocompatibility Certificates of Test for LOCTITE® Medical Device Adhesives are available via our Medical Website or by contacting Henkel directly.
Yes, CA’s should be stored in the refrigerator prior to opening, but DO NOT refrigerate them once they have already been opened. After opening, CA's should be used within 30 days for best performance.
All necessary H&S measures and PPE (personal protection equipment) requirements can be found on the product material safety data sheet, all of which are available via our website.
This is a result of stress cracking. Uncured liquid CA remaining on some plastic substrate (such as polycarbonate, acrylic, and polysulfone) in a stressed condition may cause the formation of cracks in the plastic. Some remedies for avoiding/minimizing stress cracking are closing the bond joint quickly, use reinforced grades of plastic, anneal parts, or speed the cure of the CA with accelerator (or light for light curing CA products only).
This is called blooming. This often occurs when there is an excessive amount of product being applied. To avoid blooming, use proper ventilation, less product, lower humidity, use a primer/accelerator, or a low bloom product.
Henkel has several products available with varying levels of NSF® approval, amongst others. Please contact the Henkel sales or technical teams with your requirements.
Low odor/low bloom instant adhesives are significantly higher in molecular weight than traditional instant adhesives. Therefore, they are less prone to become airborne when left open to air and consequently produce little to no blooming, or “frosting” effect on assemblies. They also tend to have lower odor during use.
-
{{#data}}
{{#distributor.isVisible}}
{{#distributor.isExpanded}}
- {{^distributor.unique}} {{/distributor.unique}} {{/distributor.isExpanded}} {{^distributor.isExpanded}} {{/distributor.isExpanded}} {{/distributor.isVisible}} {{/data}}